Lifting And Installation Of Hydraulic Press Brake

October 09, 2022

Lifting And Installation Of Hydraulic Press Brake

Lifting and installation of hydraulic plate press brake

1, hydraulic plate bending machine center of gravity is higher, before and after the light, so in the process of lifting and handling and installation must pay attention to the center of gravity position, so as not to cause machine turning over accident, lifting, lifting wire Angle as small as possible, in order to ensure the accuracy of the machine.

About hydraulic sheet metal bending machine, 2 columns in working mesa to gauge the benchmark level, vertical and horizontal direction shall be less than or equal to 1000:0.2, according to the foundation diagram pre-made, install the hydraulic sheet metal bending machine, based on the loaded anchor bolt at the same time, the final grouting, after being all cement solidification, set bolt, proofreading.

Pressure adjustment of Hydraulic Press Brake

1 hydraulic bending machine accounting pressure is based on the tensile strength of the plate accounting. If YOUR board FUNCTION IS different, admittedly accounting comes out the same, but the force of practical demand is naturally different.

2 If the external elements are the same, it is only the problem of the hydraulic bending machine, it can be adjusted through two local adjustments, one is to adjust the tensile strength of the panel in the system, the other is to adjust the DA value in the system Settings.

前

お問い合わせ

Author:

Mr. FENG

Eメール:

597053741@qq.com

Phone/WhatsApp:

+8613228888742

人気商品

You may also like

Related Categories

この仕入先にメール